AmeriWIN® Click here to return to the download page
 
 
 
 

AmeriWIN® 2.0

 

AmeriWIN™ 2.0 INSTALLATION & NOTES

AmeriWin™ Version 2.0 is designed for use as a stand alone program within Windows 95, Windows 98, Windows NT and Windows 2000 ONLY. Users desiring to generate American Cylinder drawings from within AutoCAD® need to install and use a version of AmeriCAD®. Contact American Cylinder directly (708-258-3935) or your local American Cylinder distributor for information on obtaining the appropriate version of AmeriCad® for your requirements. AmeriWin™ and the various versions of AmeriCAD® are also available for downloading from the American Cylinder WebSite: "http://www.americancylinder.com"

American Cylinder Co., Inc. has Copyrights protecting this program and the drawings produced by this program. Use of this program to produce and/or alter drawings to represent products other than American Cylinder's is in violation of the Copyrights and may result in legal action against those offenders. American Cylinder has made every effort to eliminate any errors or omissions from the program and is not responsible for any incorrect information that may be generated by AmeriWin™. American Cylinder reserves the right to add/delete or alter the information supplied by AmeriWin™ at any time without giving notice to those using the program.

I.) INSTALLATION

A.) From a 3-1/2" Floppy Disk

    • Insert the supplied AmeriWin™ disk into your computer's 3-1/2" Floppy Drive

    • Click on START and choose Run

    • Enter "A:\ ameriwin.exe" in the pop-up window that appears. ( Note: This assumes that the floppy drive on your computer is designated as drive "A:". Substitute the letter for your computer's 3-1/2" floppy drive if it is different from "A:" )

    • Click on OK to begin the AmeriWin™ Installation Program.

    • You will first be prompted to accept "C:\AmeriWin" as the default directory. This is recommended, however, you may choose to click on the Browse button to install AmeriWin™ on a different directory that already exists on your system, or create a new directory for the installation.

    • When you have completed indicating the Destination Folder (directory), click on Next to proceed with the Installation.

    • A pop-up window will appear requesting you to indicate where you would like the AmeriWin™ Program icon to appear. Follow the directions on the screen and click on Next to proceed with the installation.

    • The Setup program proceeds to install AmeriWin™. Click on Finish to complete the installation. You are now ready to use the AmeriWin™ software as indicated below.

B.) From a Folder (directory) on your Hard Drive

    • AmeriWin™ can be installed from your hard drive if AmeriWin's "ameriwin.exe" file has already been copied from the installation disk or from American Cylinder's Web Page on the Internet to your hard drive.

    • To begin the installation, click on the START Button and choose Run.

    • Enter the full pathname to the location where you have previously saved the "ameriwin.exe" file. ( ex. C:\downloads\AmeriWin\ameriwin.exe ) · Click OK to begin the AmeriWin™ Installation Program.

    • Follow the last four steps as described in section "A" above.

II.) USING THE SOFTWARE

    • To use the AmeriWin™ software, first start Windows as you normally would.

    • From the Start Menu choose the Programs menu

    • Choose American Cylinder Co., Inc.

    • Choose AmeriWin 2.0

 

Click here to return to the download page

AutoCAD® and AutoLISP® are registered trademarks of Autodesk, Inc.

AmeriWin™ is a registered trademark of American Cylinder Co., Inc.

AmeriCAD® is a registered trademark of American Cylinder Co., Inc.